1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Please help

Discussion in 'General Tech and Maintenance' started by scarface843, Aug 17, 2008.

  1. scarface843

    scarface843 New Member

    Messages:
    1
    Likes Received:
    0
    Joined:
    Aug 17, 2008
    i have 2000 civic si with b20 vtec .it has wiseco 84mm 10.4-1 pistons and eagle rods .also a all new complete stock redone head. so my problem is that it was running very strong and everything was great and today i went for a drive and it wont rev past 6700 rpm , also i dont think the vtec is even engadging. please help!
     
  2. FLounder

    FLounder power hungry VIP

    Messages:
    2,419
    Likes Received:
    137
    Joined:
    Jun 11, 2008
    Location:
    north palm beach, FL
    there are a lot of things that can make vtec not work....

    oil level too low, and a loose wire would seem to be the most common.... if you search you will find your answer im sure
     
  3. redef91

    redef91 Senior Member

    Messages:
    277
    Likes Received:
    0
    Joined:
    Jan 30, 2005
    Location:
    Boston,Ma
    yea bro just keep searching cuz even the slights bad connection on the vtec wire would throw it off not going past 6700. check if the wires r lose at the sensors cuz i had that problem on my R. they seemed they got pulled out of the sensor
     
Verification:
Draft saved Draft deleted

Share This Page