1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Port And Polish Job

Discussion in 'General Tech and Maintenance' started by 2fastaccord, Jun 3, 2003.

  1. 2fastaccord

    2fastaccord Senior Member

    Messages:
    538
    Likes Received:
    0
    Joined:
    Dec 30, 2002
    On an Accord with a good P&P job about how many hp would you typically see with basic bolt ons?

    Peace*
     
  2. CRX-YEM

    CRX-YEM Super Moderator Moderator VIP

    Messages:
    4,623
    Likes Received:
    54
    Joined:
    Sep 29, 2002
    Location:
    Wallingford, CT
    there's really no set figure, the only way to really tell would be to flow bench test the head while porting it and the a dyno test for the results.
     
  3. E_SolSi

    E_SolSi Member of the 20 nut club Moderator VIP

    Messages:
    30,036
    Likes Received:
    3,970
    Joined:
    Sep 28, 2002
    Location:
    CT
    :withstupid:
    theres no such thing as a "typical" PnP so there is no such thing as a "typical" gain
     
  4. pills_PMD

    pills_PMD Super Moderator

    Messages:
    4,232
    Likes Received:
    0
    Joined:
    Sep 30, 2002
    Location:
    New Albany, OH
    i'm hoping to get about another 30 whp and 22 ft lbs of wheel torque...
     
Verification:
Draft saved Draft deleted

Share This Page