power spraying head?

We may earn a small commission from affiliate links and paid advertisements. Terms

maksym_3

Junior Member
hi im just in the process of replacing my head gasket and i was wondering if it would be ok to use a power washer on the head to wash all that oil/coolant off or would that damage or offset the vavles and springs?
thx
 
also quick question can i use a d15z6 or
y8(though its thinnner so it will raise compression right?)
gasket on my d15b7 ?
 
should be fine just make sure you take off all the sensors because you'll fry them if they get wet. I just got mine back from the machine shop and for a valve grind, resurface, inspection, new valve seals and installation, and a hot tank it cost me 263.00 after tax. the head looked immaculate not a spec of carbon in sight.
 
Back
Top