1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Pulled shaft out of tach...

Discussion in 'General Tech and Maintenance' started by Phil_Civic, Jun 20, 2010.

  1. Phil_Civic

    Phil_Civic New Member

    Messages:
    21
    Likes Received:
    0
    Joined:
    Jul 28, 2008
    Location:
    Vancouver Island, BC, Canada
    Hey everyone,

    I have a couple clusters, but the tach in one wasn't working so I was going to swap it out, but when I went to the remove the needle on the tach the whole shaft came out...So I put the shaft back in but I'm wondering if it didn't seat correctly in the windings because it doesn't work properly at all.

    Is there anyway to correct this if the shaft has come out of the windings? Or do I need to find another tach?

    Thanks,
    Phil
     
  2. 94H_Ex

    94H_Ex Under employed

    Messages:
    1,453
    Likes Received:
    33
    Joined:
    Jun 17, 2008
    Location:
    Florida
    I would search for another tach if I were you.
     
Verification:
Draft saved Draft deleted

Share This Page