pulling codes on a P28

[BoogieDown]

i think this is for here since it has to do with ECUs but is kinda swap too.. anyhow

i have an 88 civic DX and when i do a Z6 swap w/ a P28 ecu how do i check codes? same as i do w/ my stock ECU?

sorry if this has been coverd before but haven't found any info on this

 

[tab]

Originally posted by BoogieDown@Jul 20 2004, 10:55 PM
i think this is for here since it has to do with ECUs but is kinda swap too.. anyhow

i have an 88 civic DX and when i do a Z6 swap w/ a P28 ecu how do i check codes? same as i do w/ my stock ECU?

sorry if this has been coverd before but haven't found any info on this

[post=366021]Quoted post[/post]​

I think you need a wiring diagram, because two wires need to be jumped together in order to make the engine light flash. I am guessing that you do not have the service connector needed to make this happen.