Push button starter
- Thread starter drpenguin
- Start date
- Replies 6
- Views 972
We may earn a small commission from affiliate links and paid advertisements. Terms
Pick up a factory service manual
Check out the ignition wiring
Bypass the third key position with new wires going to your push button
It's not too difficult to see what parts you need to bridge once you have the ignition module out of the steering column.
Check out the ignition wiring
Bypass the third key position with new wires going to your push button
It's not too difficult to see what parts you need to bridge once you have the ignition module out of the steering column.
hcivic.com
Senior Member
just cut run a 12v+ from the batt to the switch then to the starter. (or cut the ingnition wire)
I don't think you want all that current running through the passenger compartment, through a puny little switch, and then back out into the engine bay....
hcivic.com
Senior Member
it not that high of a current under 10 amps it only activates the solinoid it does not power it. This is how everyone i know start our trucks and cars but we only use a 1.25 momentary switch never had a problem yet
Thats how you do it