1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

PYR Chipped PR3

Discussion in 'ECU's, Electronics, and Tuning' started by cycloneb18c3, Apr 7, 2004.

  1. cycloneb18c3

    cycloneb18c3 Senior Member

    Messages:
    1,056
    Likes Received:
    0
    Joined:
    Aug 10, 2003
    Location:
    New Jersey
    ok i have a 91 integra with a b16 swap. I just got around to wiring my ecu for vtec. I connected up the vtec solenoid to pin a8, and Im still getting a CEL for code 21(vtec solenoid). I checked wiring/connections and there are no problems with it. I disconnected the solenoid wire and connected it directly to my vtec controller, and no problems, works perfect, so I try ecu again and I still get CEL. I reset the ecu and tryed again, and It still pops up that cel light. what could be wrong? when i have it connected to ecu, and lights on, I have no vtec.
    PYR Chipped PR3(obd-0)


    also tried stock pr3 and it does the same.
     
Verification:
Draft saved Draft deleted

Share This Page