1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

question about new motor

Discussion in 'HYBRID -> EG-EK / DC' started by ekPhred, Dec 15, 2003.

  1. ekPhred

    ekPhred Senior Member

    Messages:
    437
    Likes Received:
    0
    Joined:
    Nov 11, 2002
    hello! this is a stupid question but i was wondering if i bought an itr motor, could i buy cams like TODA or another cam setup while running stock bottom end? I was wondering this because the stock bottom end of a itr is obviously better then all other b series. thanks in advance! :D
     
  2. E_SolSi

    E_SolSi Member of the 20 nut club Moderator VIP

    Messages:
    30,036
    Likes Received:
    3,970
    Joined:
    Sep 28, 2002
    Location:
    CT
    yes you could

    but if you go with the spec B or spec C cams they REALLY want higher compression than even the ITR has
    the ITR has 10.6:1 USDM and 11.1:1 JDM... both of those want 12:1 or higher
    you can run them without upping the compression... but this is where you end up losing a lot of your mid range
     
  3. ekPhred

    ekPhred Senior Member

    Messages:
    437
    Likes Received:
    0
    Joined:
    Nov 11, 2002
    good lookin' out!!

    I tried looking at the articles and HS only has an article on non-vtec cams. I was wondering the difference between Spec A's - B? I don't wanna go C. gracias!
     
  4. E_SolSi

    E_SolSi Member of the 20 nut club Moderator VIP

    Messages:
    30,036
    Likes Received:
    3,970
    Joined:
    Sep 28, 2002
    Location:
    CT
Verification:
Draft saved Draft deleted

Share This Page