1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Quick help needed, D16z6 into a 93 CX, Harness Q

Discussion in 'HYBRID -> EG-EK / DC' started by 5speed4life, Dec 29, 2004.

  1. 5speed4life

    5speed4life Senior Member

    Messages:
    381
    Likes Received:
    0
    Joined:
    May 15, 2004
    Location:
    Cleveland Ohio.
    Hey real quck question. i am dropping in a z6 into my 93 cx. I have the Z6 engine harness, p28, and Stock cx ecu harness (what ever you call the harness that goes through the firewall)

    Do i need to add wires to my harness, and if so what ones and where do they pin into the ecu at?

    Eh, maybe it wasnt as quick as i hoped, but i need a quick response. thanks.
     
  2. friz

    friz Senior Member

    Messages:
    519
    Likes Received:
    2
    Joined:
    Jan 9, 2003
    Location:
    OZ
    I am assuming that the cx is a non v-tec car. You will need to run the v-tec wires in your chassis harness from the strut tower plugs to the ecu. Do a search there is lots of info on this.
     
  3. xj0hnx

    xj0hnx I wanna be sedated VIP

    Messages:
    14,172
    Likes Received:
    48
    Joined:
    Nov 10, 2002
    Location:
    C.C.TX.
Verification:
Draft saved Draft deleted

Share This Page