Rear mount won't line up

[93cxhatch]

I have a b16a1 obdo with a gsr tranny and a 94+ integra rear mount. The two holes on the bottom of the brackter that go in to the tranny area about an 1 1/2" too close???? In other words the holes on the tranny are too far apart to line up with the holes on the bracket... Anyone ever dealt with this before? I was told that my tranny was a gsr when I bought it, it showed up with a Y80 sticker on it...

 

[xj0hnx]

Sure you got the right mount?

 

[93cxhatch]

yup at least that's what I thought, but it doesn't line up.

 

[breed]

Originally posted by 93cxhatch@Apr 14 2005, 05:53 PM
yup at least that's what I thought, but it doesn't line up.

[post=487195]Quoted post[/post]​

if you have the right mount it should line up.
i used my civic rear mount and an integra bracket when i did my swap.
try to loosen the side mounts a bit and see if that helps. sometimes when you tighten to much the rear mount wont line up.

 

[ripperbone]

wrong mount

 

[SlowRider]

That was the same problem I had. bought a braket from ebay. Didnt work. So I ordered the hasport one. Got it, it looked 100% the same. But it fit perfect. I am guessing the other one was bent.