1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Release bearing fork problem!

Discussion in 'General Tech and Maintenance' started by badass5litereater, Sep 14, 2012.

  1. badass5litereater

    badass5litereater New Member

    Messages:
    2
    Likes Received:
    0
    Joined:
    Sep 14, 2012
    Hey I'm new to the site an sorry to anyone who is upset if this is in the wrong section!
    So first off my ride is a 95 civic coupe with a b18b forced induction. Now my problem is over the winter i have bin doing some pretty major work to the car and now is the re-assemble part of my project. My problem is I have bolted my tranny back on and was pretty sure everything was done right. Now I'm trying to put my slave cylinder back on but the fork is barely moving.(brand new slave cylinder). Like its so tight can barly get the slave on like have to force it for the bolt to match up on the bell housing and thats as far as the fork goes twords the passenger side! Did i put the fork and bearing on wrong? Any ideas/questions greatly appreciated thanks.
     
  2. badass5litereater

    badass5litereater New Member

    Messages:
    2
    Likes Received:
    0
    Joined:
    Sep 14, 2012
    Anybody? If you have questions that could help with the answer please ask them!
     
Verification:
Draft saved Draft deleted

Share This Page