1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Removing the wrist pins?

Discussion in 'Engine Building' started by Slimtadder, Jan 1, 2003.

  1. Slimtadder

    Slimtadder Senior Member

    Messages:
    148
    Likes Received:
    0
    Joined:
    Sep 29, 2002
    Location:
    Lake Havasu City, AZ.
    Can I get a hand here. Need to get the wrist pins out of B16 rods? How do I do this?

    Thanks
     
  2. cws13

    cws13 Senior Member

    Messages:
    484
    Likes Received:
    0
    Joined:
    Nov 15, 2002
    Location:
    Athens,GA
    Have you looked for snap rings at the ends of the pins. I can't remember off the cuff. I can check a shop manual at work tomorrow if that's not it.
     
  3. pissedoffsol

    pissedoffsol RETIRED

    Messages:
    49,693
    Likes Received:
    53
    Joined:
    Sep 28, 2002
    Location:
    Retirement Home
    bring them to a machine shop
     
  4. Slimtadder

    Slimtadder Senior Member

    Messages:
    148
    Likes Received:
    0
    Joined:
    Sep 29, 2002
    Location:
    Lake Havasu City, AZ.
  5. chevy302dz

    chevy302dz Senior Member

    Messages:
    209
    Likes Received:
    0
    Joined:
    Oct 1, 2002
    They have to be pressed out so your best bet is to bring them to a shop, unless you have access to a hydrolic press.
     
  6. phunky.buddha

    phunky.buddha Admin with a big stick Admin VIP

    Messages:
    28,465
    Likes Received:
    228
    Joined:
    Sep 30, 2002
    Location:
    Dallas / Fort Worth, TX

    Hydraulic.

    Sorry, it's just one of my pet peeves...
     
Verification:
Draft saved Draft deleted

Share This Page