1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Sensor of some kind ZC with 2 blue wires

Discussion in 'ECU's, Electronics, and Tuning' started by cheese9988, Feb 20, 2004.

  1. cheese9988

    cheese9988 Senior Member VIP

    Messages:
    1,990
    Likes Received:
    251
    Joined:
    Apr 25, 2003
    Location:
    Lowell, MA
    I am putting the wireharness on my zc and I noticed that that there is some device on the end of the first camshaft closest to the exaust manifold, with two blue wires on it. What is this thing and what does it hook too. So far everything matched up ok, but I am mixing a dx and si wireharness to make things work.
     
  2. D See 2

    D See 2 Senior Member

    Messages:
    2,405
    Likes Received:
    0
    Joined:
    Sep 29, 2002
    Location:
    Baltimore, MD
    CYP (cylinder position sensor). it is needed for proper function of the engine. it advances/retards timing according to engine rpm.
     
  3. unisonsentra

    unisonsentra Junior Member

    Messages:
    2
    Likes Received:
    0
    Joined:
    Mar 9, 2004
    C1=original orange/ now=blue/green wire in the cylinder position plug.
    C2=original white/now=blue/yellow wire in the cylinder position plug
    from ecu
    then those wires form c1 and c2 hook up to
    B10= orange
    B12=white
    Take the needed pins from b2 and b11.
    hope it helps!!!!
     
Verification:
Draft saved Draft deleted

Share This Page