1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Shot Peening rods?

Discussion in 'Engine Building' started by Sprocker, Dec 30, 2002.

  1. Sprocker

    Sprocker Senior Member

    Messages:
    137
    Likes Received:
    0
    Joined:
    Nov 25, 2002
    I am looking to build my engine, no one makes rods for my car and I am only looking to run like 12-14 psi so do you think that if I buy forged pistons and then get my rods shot peened it will be strong enough! Thanks for any help! This is for an Accord F23a1 Vtec engine! Also the revs are only going to 6,300.
     
  2. cws13

    cws13 Senior Member

    Messages:
    484
    Likes Received:
    0
    Joined:
    Nov 15, 2002
    Location:
    Athens,GA
    no, and you can have custom rods made. Take the turbo money and buy an H22. You'll end up in the same place and have reliability.
     
Verification:
Draft saved Draft deleted

Share This Page