1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

side molding removal??

Discussion in 'Body / Exterior / Interior / Cosmetics' started by Stille Nacht, Dec 2, 2009.

  1. Stille Nacht

    Stille Nacht New Member

    Messages:
    21
    Likes Received:
    0
    Joined:
    Oct 27, 2009
    Location:
    Texas
    Im trying to remove the side molding of my ek. Is there any way to do it without damaging the paint?
    Im half tempted to used a small pry bar to take it off, im just worried bout damaging the paint. Any help would be awsome.:D
     
  2. tabKola

    tabKola New Member

    Messages:
    326
    Likes Received:
    5
    Joined:
    Jul 3, 2008
    Location:
    Tewksbury MA
    There are clips behind the moldings that hold them on. Fender is 2 clips, door is 7 clips and a plastic nut and maybe some tape behind it, and rear is 3 clips. Just squeeze the sides of the clip together and push to remove. If you have to pry use a flathead wrapped in tape and put tape on the car above/below the moldings to avoid damage.
     
  3. Stille Nacht

    Stille Nacht New Member

    Messages:
    21
    Likes Received:
    0
    Joined:
    Oct 27, 2009
    Location:
    Texas
    Cool. Thanks for the tip.
     
Verification:
Draft saved Draft deleted

Share This Page