1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

SLEEVES??

Discussion in 'Engine Building' started by RED_95_GSR, Jan 11, 2005.

  1. RED_95_GSR

    RED_95_GSR Junior Member

    Messages:
    24
    Likes Received:
    0
    Joined:
    May 10, 2004
    does a 83mm bore on a b18c1 block require sleeving?

    also, does a 3.205 bore reqire sleeving?

    thanks
     
  2. nfn15037

    nfn15037 Senior Member

    Messages:
    670
    Likes Received:
    0
    Joined:
    Mar 1, 2004
    3.205" = 81.407 mm, should be OK on stock sleeves, as many go out to 81.50 with no issues. Many recommend against 83mm bore on stock slee,es, that doesn't leave much meat left on the sleeves, but I suppose it all depends on what you are doing with the block. Personally, I would not run 83mm on stock sleeves.
     
Verification:
Draft saved Draft deleted

Share This Page