1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

SOHC HEAD

Discussion in 'Engine Building' started by pappa, Sep 4, 2003.

  1. pappa

    pappa Junior Member

    Messages:
    3
    Likes Received:
    0
    Joined:
    Sep 4, 2003
    Whats up!

    I drive a 93 honda civic dx coupe. i was on this forum about a year and a half ago.
    i had an automatic tranny..(ouch) since then i put in a manual..(i have pics of the swap)tranny. dropped it 3 inches and aftermarket sideskirts...my question is

    i have the 1.5 SOHC non Vtec head. I got a Vtec head off of a D16Z6 in the junkyard. how hard would it be to swap heads....and is there anything i would have to do...ie drilling......

    holla back!
     
  2. phunky.buddha

    phunky.buddha Admin with a big stick Admin VIP

    Messages:
    28,465
    Likes Received:
    228
    Joined:
    Sep 30, 2002
    Location:
    Dallas / Fort Worth, TX
    Not too hard at all- it's a lot easier than LS/VTEC. Go read up some in the forums- there's tons of information about mini-me setups already. Welcome back to the board!
     
Verification:
Draft saved Draft deleted

Share This Page