1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Spoon

Discussion in 'Engine Building' started by wisemansoji, Jun 22, 2003.

  1. wisemansoji

    wisemansoji Senior Member

    Messages:
    175
    Likes Received:
    0
    Joined:
    Dec 17, 2002
    will the spoon ventuli plate work with a skunk2 intake manifold.
     
  2. JDMilan

    JDMilan Senior Member

    Messages:
    6,730
    Likes Received:
    0
    Joined:
    May 11, 2003
    Location:
    Boca Raton, FL
    considering since the skunk2 unit is a knock off of the ITR unit, then it should. You might have to specify which head you have if spoon offers them for the SiRG.



    Milan
     
  3. vtecsir1

    vtecsir1 Senior Member

    Messages:
    3,313
    Likes Received:
    17
    Joined:
    Dec 5, 2002
    Location:
    Orlando, FL

    yes
     
  4. pissedoffsol

    pissedoffsol RETIRED

    Messages:
    49,693
    Likes Received:
    53
    Joined:
    Sep 28, 2002
    Location:
    Retirement Home
    i don't recommend you get it, unless you are running a b16a/b on road course, where mid range is important, and top end isn't so much.

    on a 1.8, it will act as a restricter plate.

    on a 1.6, it gives it more midrange, but still eats some power up top.
     
  5. pills_PMD

    pills_PMD Super Moderator

    Messages:
    4,232
    Likes Received:
    0
    Joined:
    Sep 30, 2002
    Location:
    New Albany, OH
    get the hondata intake manifold gasket YO
     
  6. JDMilan

    JDMilan Senior Member

    Messages:
    6,730
    Likes Received:
    0
    Joined:
    May 11, 2003
    Location:
    Boca Raton, FL
Verification:
Draft saved Draft deleted

Share This Page