1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Spun Bearing? What To Do

Discussion in 'Engine Building' started by crag1177, Apr 25, 2003.

  1. crag1177

    crag1177 Junior Member

    Messages:
    1
    Likes Received:
    0
    Joined:
    Apr 25, 2003
    :angry: I swapped a 95 gsr motor into my 94 civic. It ran fine, and then one night my dumbass Momo pedals that I had to match with everything else got stuck on my stupid ass Momo floor mats. Anyway I spun a bearing. I am not sure which one yet. Do you know how difficult is it to fix? The guy that I go to for work says I should just do an lsvtec swap since I already have everything else (except the block). which is cheaper and which is more of a pain in the ass? Any help would be appreciated. :wtf: :wtf: :wtf:
     
  2. chet

    chet Senior Member

    Messages:
    888
    Likes Received:
    0
    Joined:
    Sep 30, 2002
    Location:
    st petersburg, florida
    make sure your crank is good...

    then re-use the gsr block...as ls/vtec's just aren't as good...
     
  3. liquid00meth

    liquid00meth Senior Member

    Messages:
    3,201
    Likes Received:
    0
    Joined:
    Nov 26, 2002
    Location:
    Laconia, NH
    depends how much damage it caused man. You at least probably have one rod assembly thats no good, it depends if it smashed the crank etc.
     
Verification:
Draft saved Draft deleted

Share This Page