AccordH23Avtec
New Member
00 Accord H23a Vtec with a chipped p28 h22 basemap
So I converted from 3 wire IAVC to 2 wire had car on not realize it(on position engine not running), blew a fuse, replaced fuse.
Now my car is throwing code 9 which is Cylinder position sensor no power to etc... Check with a DMM 335 ohms, recommend is 350-700. I am not sure if it is the sensor or the wiring. I have checked conversion harness every is good except when I wiggle the wire on B plug and I hear a click with key on the on position sometimes it trys to start which is weird to me.
Now my problem is the car is starting hard and then dying.
As the video shows
VIDEO0010 - YouTube
So I converted from 3 wire IAVC to 2 wire had car on not realize it(on position engine not running), blew a fuse, replaced fuse.
Now my car is throwing code 9 which is Cylinder position sensor no power to etc... Check with a DMM 335 ohms, recommend is 350-700. I am not sure if it is the sensor or the wiring. I have checked conversion harness every is good except when I wiggle the wire on B plug and I hear a click with key on the on position sometimes it trys to start which is weird to me.
Now my problem is the car is starting hard and then dying.
As the video shows
VIDEO0010 - YouTube