1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

starting problems

Discussion in 'ECU's, Electronics, and Tuning' started by ^crx^, Jun 13, 2005.

  1. ^crx^

    ^crx^ Senior Member

    Messages:
    162
    Likes Received:
    0
    Joined:
    Jun 19, 2004
    after swapping out my old obd0 system for a new obd1. with a p28 ecu and a TD44U dizzy but i have not replaced my peak and hold injectors.

    but the strange thing is that im getting spark on all 4 plugs, and i can smell the gas fumes from my new spark plugs. and my car wont start!!
    but the new dizzy have not a cyl #1 mark for where to put the wire. can some one post a picture/tell me where the right place for each wire?
    what can be the problem here? toasted resistor box? wrong ignition timing?
     
  2. ^crx^

    ^crx^ Senior Member

    Messages:
    162
    Likes Received:
    0
    Joined:
    Jun 19, 2004
    BUMP!

    should i move this post?
     
Verification:
Draft saved Draft deleted

Share This Page