1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

stock bottom end

Discussion in 'General Tech and Maintenance' started by rudeludenotmeanthough, Nov 12, 2003.

  1. rudeludenotmeanthough

    rudeludenotmeanthough Senior Member

    Messages:
    1,406
    Likes Received:
    0
    Joined:
    Sep 29, 2002
    What do you guys/girls think about boosting on stock honda bottom ends? they seem to be strong. I am going to boost my b20a (90 prelude 2.0 si), but before i do i would like to make sure my motor is up to the challange. My goal is 200 WHP or less, on a STOCK motor. Maybe later down the road, if i build up the motor i will run something a little more usefull. But for now, 200WHP would be better than the 140 i have now...

    your thoughts?
     
  2. 92civicb18b1

    92civicb18b1 The Trisexual

    Messages:
    8,859
    Likes Received:
    18
    Joined:
    Oct 1, 2003
    Location:
    The asshole of the USA, New Jersey
    I think that it could handle 5-7 psi, I wouldn't go more than that though.
     
  3. JDMilan

    JDMilan Senior Member

    Messages:
    6,730
    Likes Received:
    0
    Joined:
    May 11, 2003
    Location:
    Boca Raton, FL
    make sure she is in good running order, otherwise something will take a shit very soon.
     
  4. daviid

    daviid Member

    Messages:
    49
    Likes Received:
    0
    Joined:
    Jul 6, 2003
    Location:
    Concord, NC
    the b20a and the b21a are honda's worst motors. i wouldnt touch them
     
  5. turbo4dr

    turbo4dr Member

    Messages:
    59
    Likes Received:
    0
    Joined:
    Sep 16, 2003
    honda motors will take a little more boost than 7 but i wouldn't go above 10 on stock pistons and rods with out some sort of management system. I just have srp pistons and i run 15 psi sometimes, but never the less at five psi it will put you in the seat
     
Verification:
Draft saved Draft deleted

Share This Page