1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Strange EK Swap Issues

Discussion in 'HYBRID -> EG-EK / DC' started by sleepn_accord, Jul 25, 2003.

  1. sleepn_accord

    sleepn_accord Senior Member

    Messages:
    235
    Likes Received:
    0
    Joined:
    Jul 25, 2003
    Just to ensure all my facts are correct:

    The car is a 96 Civic DX

    Motor: B16A2

    When we did the swap we changed the ENTIRE wire harness all the way back to the ECU.

    Now, first I can't even find the stupid service jumper to read the codes.

    Anyway:

    My understanding was that this motor was an OBD2, when the swap was done the car ran fine. Only thing was that vehicle no longer has Speed or Tach readings.
    Is this common?

    *I know I should buy a manual, but they're next to impossible to find on this island right now*

    All help is greatly appreciated (and corrections of my ignorance)! :D
     
  2. darwins_vtech

    darwins_vtech Senior Member

    Messages:
    250
    Likes Received:
    0
    Joined:
    Jun 4, 2003
    Location:
    Wisconsin
    Check the plug for the speed. It should be the one on the top of the tranny. are you throwing any check engine light?

    Darin
     
  3. sleepn_accord

    sleepn_accord Senior Member

    Messages:
    235
    Likes Received:
    0
    Joined:
    Jul 25, 2003
    yes it's throwing a light, but as I mentioned I can't find the service jumper.. :(
     
Verification:
Draft saved Draft deleted

Share This Page