1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

swap problem

Discussion in 'Civic and CRX - EF' started by little90, Oct 10, 2009.

  1. little90

    little90 New Member

    Messages:
    28
    Likes Received:
    0
    Joined:
    Jun 21, 2009
    Location:
    Snohomish WASH
    i have a 90 civic that i putt a b18a motor in and got a pr4 ecu got the harness done by hondaswap .com and got it all installed but wont turn over check all the basics. when i try to turn it over a relay clicks under the dash please help someone :confused:
     
  2. spoilt

    spoilt New Member

    Messages:
    13
    Likes Received:
    0
    Joined:
    Oct 5, 2009
    sounds like flat battery, or a dodgy starter motor. give the starter a little hit with hammer it sounds dodgy but some time works. and there is a single wire going to starter solenoid, check to make sure it is getting power when key is turned to start cheers.
     
  3. Bobby17772

    Bobby17772 New Member

    Messages:
    785
    Likes Received:
    6
    Joined:
    Jun 11, 2009
    Location:
    Enfield, CT
    it's probably your starter
     
  4. little90

    little90 New Member

    Messages:
    28
    Likes Received:
    0
    Joined:
    Jun 21, 2009
    Location:
    Snohomish WASH
    had started check and its good the one wire to the starter doesnt have a lot of power to it when i put a volt meter to it thanks
     
Verification:
Draft saved Draft deleted

Share This Page