1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

teg cluster in a crx/ speedo wont work need help

Discussion in 'HYBRID -> ED-EF / DA' started by auditt225, Oct 1, 2007.

  1. auditt225

    auditt225 New Member

    Messages:
    23
    Likes Received:
    0
    Joined:
    Aug 29, 2007
    so I have an ls swap in my crx. I changed the cluster to an integra since my ef was dead. Anyway I took a 93 vss out of a civic and installed it to my ls. I looked over at all of the websites how to do the swap but my speedometer is still not working. Wires on the vss BLACK(GROUND), ORANGE(SIGNAL), YELLOW(POWER). Is this right? I know the orange goes back on the teg cluster pin a11 which is orange.
     
  2. K2e2vin

    K2e2vin Senior Member

    Messages:
    8,446
    Likes Received:
    92
    Joined:
    Jan 2, 2003
    Location:
    Raleigh, NC
    The signal wire should also go to the dash. Splice it!
     
  3. auditt225

    auditt225 New Member

    Messages:
    23
    Likes Received:
    0
    Joined:
    Aug 29, 2007
    This is what I did, Black went to a ground, yellow went to a power source, and orange went to the teg cluster pin a11 which is orange for the speedo. I also spliced it to the ecu pinb16. Still nothing. I have gone through 2 vss and still nothing. I have looked and tried every single website that has posted it. I need help!!!
     
Verification:
Draft saved Draft deleted

Share This Page