Discussion in 'Engine Building' started by AllMotorB18Civic, May 13, 2005.
What is the torque spec to tighten down ARP Head studs for a GSR motor using ARP moly lube?
Torqued mine to 85...
tq'd mine to 65
make sure you two step the torque and not just torque them all the way down on the first shot.
i did it like this...
22lbs > 45 lbs > 65 lbs
my ARP headstuds came with INSTRUCTIONS to torque to 72 ft/lbs. And yes you should torque in a two step manner.
maybe I should retorque mine?
Separate names with a comma.