1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Tranny Questions?

Discussion in 'Engine Building' started by sleeper88, Nov 28, 2006.

  1. sleeper88

    sleeper88 My mom thinks i'm cool

    Messages:
    434
    Likes Received:
    4
    Joined:
    Dec 18, 2005
    Location:
    Parkesburg, pa
    I need to know what years and make(honda or acura) that the ys1 came out of. I need to get a keeper pin for the shifter linkage. Next one. After cracking the tranny case what is a good sealant for putting it back together? last ? What is the torque specs for the tranny case? Thank you for your help
     
  2. sleeper88

    sleeper88 My mom thinks i'm cool

    Messages:
    434
    Likes Received:
    4
    Joined:
    Dec 18, 2005
    Location:
    Parkesburg, pa
    Well i found out that the ys1 cable trans comes out of 91 integra. so all i need is a good sealant to put on the case and the torque specs for the bolts for the case.
     
  3. D See 2

    D See 2 Senior Member

    Messages:
    2,405
    Likes Received:
    0
    Joined:
    Sep 29, 2002
    Location:
    Baltimore, MD
    I use Permatex Ultra Grey for the sealant. It is imperative that both mating surfaces be clean and dry. I spray brakleen on a shop rag and wipe the surfaces down. It does a really good job of evaporating any oil.

    Torque on the tranny case bolts is 20 lb/ft. as per a 1995 Integra service manual.
     
  4. sleeper88

    sleeper88 My mom thinks i'm cool

    Messages:
    434
    Likes Received:
    4
    Joined:
    Dec 18, 2005
    Location:
    Parkesburg, pa
    Thank you very much. I just want to get this right. I dont want to mess anything up.
     
Verification:
Draft saved Draft deleted

Share This Page