1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Tryin To Build A Ls/vtec

Discussion in 'Engine Building' started by homewood, Jan 12, 2003.

  1. homewood

    homewood Junior Member

    Messages:
    3
    Likes Received:
    0
    Joined:
    Dec 2, 2002
    i was wandering if anyone knew a website or somewhere i could go to get good info on everything i would need to do for a b18b/b18c1 hybrid.
    THANKS GUYS
     
  2. prawjEKt Cx

    prawjEKt Cx Senior Member

    Messages:
    551
    Likes Received:
    1
    Joined:
    Jan 3, 2003
    Location:
    upstate NY
    click the tab that says articles.. then go back about 3 or 4 pages and click on the ls/vtec info
     
  3. lsvtec

    lsvtec GNU/Linux Evangelist

    Messages:
    5,453
    Likes Received:
    4
    Joined:
    Sep 30, 2002
    Location:
    Greater Portland, OR
    There is also a lot of information in our FAQ. Come back with any specific questions that you have after reading these.
     
  4. ericmugen

    ericmugen Junior Member

    Messages:
    25
    Likes Received:
    0
    Joined:
    Jan 2, 2003
    Location:
    Puerto Rico
    www.inlinefour.com sell a ls-vtec hardware kit that includes all necesary fittings, braided line and instructions to make an ls-vtec. Enter the page, select motor, accesories and ls-vtec hardware kit.
     
  5. prawjEKt Cx

    prawjEKt Cx Senior Member

    Messages:
    551
    Likes Received:
    1
    Joined:
    Jan 3, 2003
    Location:
    upstate NY
    yeah theres one on jdmhondaparts too.... just look at the picture, i saw all the shit at lowes to make it... if some of you guys don't have a lowes it's like a home depot, home improvement store.
     
Verification:
Draft saved Draft deleted

Share This Page