1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Turbo b16 question

Discussion in 'Forced Induction' started by eg6sirguy, May 23, 2008.

  1. eg6sirguy

    eg6sirguy New Member

    Messages:
    3
    Likes Received:
    0
    Joined:
    May 22, 2008
    I have a b16 block sitting around and while it's all apart i figured i was going to get new pistons to lower the compression and eagle rods. Was wondering if going over 10psi would be safe with a block guard. If so, how much more?
     
  2. LS_VTEC

    LS_VTEC you get the BRAKE

    Messages:
    2,616
    Likes Received:
    25
    Joined:
    Dec 11, 2007
    Location:
    NJ
    Search the forum, its been covered.
     
  3. Turbo&Auto

    Turbo&Auto Nick Go FAST!!

    Messages:
    3,269
    Likes Received:
    29
    Joined:
    Jan 9, 2006
    Location:
    East Burg, PA!
    Search block filling. If youre going to have it all apart, might as well :)
     
  4. amadeuscr

    amadeuscr Member

    Messages:
    172
    Likes Received:
    2
    Joined:
    May 13, 2007
    Find all the posts started by me , you will see my setup , with low comp pistons and eagle rods , a lot of people helped me and gave me all this good advices. very good experienced people here !
     
  5. LS_VTEC

    LS_VTEC you get the BRAKE

    Messages:
    2,616
    Likes Received:
    25
    Joined:
    Dec 11, 2007
    Location:
    NJ
    Like DJ KHALED says... "we're the bessssssst". :thumbsup:
     
  6. eg6sirguy

    eg6sirguy New Member

    Messages:
    3
    Likes Received:
    0
    Joined:
    May 22, 2008
    thanks for the responses guys
     
Verification:
Draft saved Draft deleted

Share This Page