1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

uhh-0hh running ITR on obd0

Discussion in 'ECU's, Electronics, and Tuning' started by hammerdgolfer, Feb 14, 2004.

  1. hammerdgolfer

    hammerdgolfer Senior Member

    Messages:
    275
    Likes Received:
    0
    Joined:
    Nov 21, 2003
    so after my little ups claim goes through im making an extra 700 bucks so i can pull out all the stops and get a itr swap, i already has hasport mounts(with hydro tranny) and hasport shift linkage, now i was wondering to myself, what am i going to do about the wires....

    i am getting the obd0 vtec engine harness off a b16 cable swap and will i have to get the distributor too? or will my 91 si distributor work??
    what am i going to do about the ecu though? ? can i use a obd0 b16? get that reprogrammed or can i just have a new one built and WHERE AT??
     
  2. pissedoffsol

    pissedoffsol RETIRED

    Messages:
    49,693
    Likes Received:
    54
    Joined:
    Sep 28, 2002
    Location:
    Retirement Home
    what car is this going into? not all 4th gens are the same
     
Verification:
Draft saved Draft deleted

Share This Page