1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Use a AT Engine Harness on MT?

Discussion in 'HYBRID -> EG-EK / DC' started by dkgoodrich, Jan 12, 2006.

  1. dkgoodrich

    dkgoodrich Junior Member

    Messages:
    27
    Likes Received:
    0
    Joined:
    Jan 11, 2006
    Hi, I am installing a 93 b18a1 into my 93 civic ex

    I need a 94/95 LS engine harness for everything to plug up, The only one I can find goes to a automatic tranny.

    Can I use this harness?

    I also found some to a d16z6 and GSR but not sure if they will work either.
     
  2. Chaos325

    Chaos325 Member

    Messages:
    117
    Likes Received:
    0
    Joined:
    Mar 27, 2004
    Location:
    Collingswood, NJ
    probably could. you'd have to run wires for reverse lights if different
     
  3. dkgoodrich

    dkgoodrich Junior Member

    Messages:
    27
    Likes Received:
    0
    Joined:
    Jan 11, 2006
    Thanks man, I was looking for someone that has done a 5 spd conversion.
     
  4. brian11to1

    brian11to1 Senior Member

    Messages:
    9,203
    Likes Received:
    21
    Joined:
    Jan 9, 2003
    i used an auto harness in my integra, had no issues.
     
  5. dkgoodrich

    dkgoodrich Junior Member

    Messages:
    27
    Likes Received:
    0
    Joined:
    Jan 11, 2006

    Thanks man, I was worryed about it thinking it was always in park and wouldnt start and no place for the clutch start switch either. I figured it was possible but didnt know how involved it was.

    I ended up getting a $30.00 Si OBDI harness, I lucked out on it. I got it off eBay, most of them were going for 90$ - !00$. It should be just like my d16z6 harness I used to have, but it was listed 'obd1 si'. No one else bid on it.

    Thanks for your all the help.

    Daniel
     
Verification:
Draft saved Draft deleted

Share This Page