vacuum lines

[cycloneb18c3]

I had a swap done to my car-91 integra b16a2 engine, and I discovered that the kids took out the evap canister(charcoal canister). I would like to hook this back up but I have no Idea which hose goes where for it. I have a haynes manual, but there isnt any vacuum lines. They used the stock integra(91) throttle body too. Just need to know where to connect the lines to. a good diagram would help if anyone can scan one and load it onto here. thanks, dan

 

[cycloneb18c3]

also is my alternator going bad if the battery light keeps comming on at around 3500 rpm? it will stay on for like 10-15 minutes then go out. I used the stock alternator from the ls, which has been replaced(only max 10,000 miles in it). I tightened the belt, which is fine. battery is still good.

 

[bryan]

this is a vacum diagram for a b16a gen one but it might help u get an idea of how the lines run check it out at

Webpage

hoprfully it will help you