1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Valve Lash settings?

Discussion in 'Engine Building' started by 97SIRTN, May 25, 2005.

  1. 97SIRTN

    97SIRTN Member

    Messages:
    188
    Likes Received:
    0
    Joined:
    Jan 22, 2005
    I just have the CTR intake cam going into my b16.
    Do I set the valve lash's for the b16 or for CTR spec for the intake cam.
    What would those be by the way, couldn't find it my Haynes or Chilton. Can't find a Helm's in Nashville.
    Thanks for the info.
     
  2. xj0hnx

    xj0hnx I wanna be sedated VIP

    Messages:
    14,172
    Likes Received:
    48
    Joined:
    Nov 10, 2002
    Location:
    C.C.TX.
    I had this exact same question. I just set mine to B16A because the CTR is still a 1.6 and I don't think it would be that far off, has been fine ever since.

    Intake 0.15-0.19
    Exhaust 0.17-0.21

    The chatter afterwards was a little louder, but not too bad, and it hasn't had an issue yet.
     
  3. 97SIRTN

    97SIRTN Member

    Messages:
    188
    Likes Received:
    0
    Joined:
    Jan 22, 2005
Verification:
Draft saved Draft deleted

Share This Page