1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

vinyl dye

Discussion in 'Body / Exterior / Interior / Cosmetics' started by brian11to1, Jul 8, 2006.

  1. brian11to1

    brian11to1 Senior Member

    Messages:
    9,203
    Likes Received:
    21
    Joined:
    Jan 9, 2003
    black door panels are hard as shit to find for my integra sedan.

    so, im thinking of dying them. any tips or tricks on how to do so?
     
  2. street_racer_271

    street_racer_271 adrenaline is my high

    Messages:
    134
    Likes Received:
    0
    Joined:
    Jun 26, 2006
    Location:
    manitoba
    clean them like 3 or 4 times to get all the armoral off, and then start with thin coats of dye, let it dry for about an hour or so, then apply more every 10-15 minutes, depending on when it dries, but you'll probably need to leave it (once your satisfied) for 72 hours to fully soak in and dye before touching it too much, i did my dash just this last winter, turned out amazing, it doesn't scratch or flake what so ever
     
  3. hcivic.com

    hcivic.com Senior Member

    Messages:
    4,571
    Likes Received:
    2
    Joined:
    Jan 7, 2003
    Location:
    Calgary Alberta canada
    if you can pull tha panel out of the car and set up on a flat surface it will make the job 100x easier if you can walk all around every panel
     
  4. brian11to1

    brian11to1 Senior Member

    Messages:
    9,203
    Likes Received:
    21
    Joined:
    Jan 9, 2003
    ill be removing the panels, i dont mind driving without them, ive done it before.
     
Verification:
Draft saved Draft deleted

Share This Page