VX 5 Wire To 4 Wire pictures not showing.

We may earn a small commission from affiliate links and paid advertisements. Terms

Nobody can help me here? i just wold like the pictures as a reference so i dont screw it up. please someone give me a little help here.
 
Tink2160 said:
Does anyone know why the pictures in this write up are not showing. i need to do this on my car and need the pictures so i know what i am doing. here is the link to the thread.

https://hondaswap.com/swap-articles/vx-5-wire-4-wire-o2-sensor-info-13759/

or does someone know where i can find the pictures? any help would be great i need to get this done so i can get on to installing my turbo setup.
Click to expand...

SIMPLE. Not pictures needed. You need the obd1 pinout in order to do this.
Just rewire the following

O2 Sensor Input - WHT to D14 (needs to be a shielded wire)
Heater Control - BLK to A6
Sensor Ground - GRN to D22
Sensor Voltage - BLK to A25 or B1 (both are 12-volt sources, so either works fine.)


edit: heres your pinout link https://hondaswap.com/reference-materials/ecu-pinouts-28667/
 
i was thinking that was all it is to do after reading the how to section... what i was worried about is i wanted to do it using the factory vx engine harness. so i wanted the pictures so i knew what i was doing that way is all. i mean im sure i could figure it out with time and efort. i just figured the pictured would make it alot easier...
 
You must log in or register to reply here.
Back
Top