1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

what and where to get oil feed"T" fitting for H22

Discussion in 'Forced Induction' started by TeamUrbanChaos, Sep 15, 2006.

  1. TeamUrbanChaos

    TeamUrbanChaos Certified H22 Super-tech

    Messages:
    472
    Likes Received:
    0
    Joined:
    Jan 20, 2004
    Location:
    Home Of ThE LoSt Towers
    Just recently picked up a turbo setup for my JDM H22 and was wondering what and where can i get an oil feed "T" fitting to go on the oil sensor inlet on the back of the block.....( which i heard is the best place to run the oil feed line).

    please let me know. thanks:D
     
  2. TeamUrbanChaos

    TeamUrbanChaos Certified H22 Super-tech

    Messages:
    472
    Likes Received:
    0
    Joined:
    Jan 20, 2004
    Location:
    Home Of ThE LoSt Towers
    anyone?
     
  3. civicious

    civicious FüK-VTEC VIP

    Messages:
    9,855
    Likes Received:
    629
    Joined:
    Jun 15, 2003
    Location:
    Houston, TX
    Home Depost should have it...just make sure to get the right thread size. Unscrew your oil psi sensor and take it up there with you, and find a fitting that matches your thread.
     
  4. pissedoffsol

    pissedoffsol RETIRED

    Messages:
    49,693
    Likes Received:
    53
    Joined:
    Sep 28, 2002
    Location:
    Retirement Home
    i really don't like those T's. too many horror stories. Get an oil filter sandwhich adapter from GEmfg
     
Verification:
Draft saved Draft deleted

Share This Page