What else do i need

[DeCoY]

Ok so I'm putting a JDM B18C (gsr) motor into my 1990 honda civic SI as most of you probably already know. I just want to list off all i have so far and if any of you have any advice on what else i will need, Feel free to let me know.

So far i have:

Complete B18c Swap (including ECU and Hydro transmission)
GSR Axels
89-91 civic with B series- Shift linkage
89-91 Civic with B series- Mount kit (including Cable clutch to hydro tranny conversion bracket)
OBD-0 Chassis to OBD 2a Wiring conversion harness
GSR HEADER and 2.5 inch CATCO cat with 2.5 inch exaust.
Short ram GSR Intake Pipe/filter

ANY advice you might have for me before i start this project would be GREATLY appreciated.

 

[ripperbone]

when I had my swap done I have a new clutch put in, new seals and gaskets (real main, oil pan, head gasket, cam seals, axle seals, valve cover gasket), you might do a timing belt and water pump also, new plugs, cap and rotor, and wires are good to have replaced also

 

[DeCoY]

Ok i will look into that tho my budget is getting close... but is there any other parts i will need??