1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

What Head Gasket And Intake Manifold

Discussion in 'HYBRID -> EG-EK / DC' started by jbzny1, Jun 10, 2003.

  1. jbzny1

    jbzny1 Junior Member

    Messages:
    4
    Likes Received:
    0
    Joined:
    Jun 8, 2003
    If i do the b16 head on the b18 block what head gasket intake manifold and header do I use
     
  2. pills_PMD

    pills_PMD Super Moderator

    Messages:
    4,232
    Likes Received:
    0
    Joined:
    Sep 30, 2002
    Location:
    New Albany, OH
    oem LS headgasket
    the b16 intake manifold will work .. i opted for an ITR one..
    you can use a b16 header / an itr header / and maybe a gsr one too
     
  3. RV1TOOMANY

    RV1TOOMANY Junior Member

    Messages:
    21
    Likes Received:
    0
    Joined:
    May 3, 2003
    JUST CHECK THE SWAP SECTION AND YOU'LL GET THE INFORMATION YOU NEED. I THOUGHT ABOUT LS VTEC, BUT I THINK IT WILL TO EXPENSIVE. SO I WILL JUST GO TURBO LS. :worthy:
     
  4. JDMilan

    JDMilan Senior Member

    Messages:
    6,730
    Likes Received:
    0
    Joined:
    May 11, 2003
    Location:
    Boca Raton, FL
    Pills is right, I would go with a Skunk2/ITR unit, personally a SMSP header but the JDM ITR is very very nice also.


    Milan
     
  5. deth101

    deth101 Senior Member

    Messages:
    774
    Likes Received:
    0
    Joined:
    Mar 17, 2003
    Location:
    usa
    I like the JDM ITR header because it has the stock heat sheild mount for the ultra sleeper look
     
  6. JDMilan

    JDMilan Senior Member

    Messages:
    6,730
    Likes Received:
    0
    Joined:
    May 11, 2003
    Location:
    Boca Raton, FL
    I love the oem finish look but that header weighs a good amount as compared to other aftermarket units. I am picky on weight savings, this is just me......


    Milan
     
Verification:
Draft saved Draft deleted

Share This Page