1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

What is needed for D16Z6 into Civic CX

Discussion in 'HYBRID -> EG-EK / DC' started by spooncivic01, Aug 11, 2003.

  1. spooncivic01

    spooncivic01 Junior Member

    Messages:
    19
    Likes Received:
    0
    Joined:
    Jul 15, 2003
    Hey everyone I want to put the D16Z6 into a 93 Civic CX. What are the nessacry parts to put it in I don't believe it is too hard just a direct bolt-in. I know everyone wants to know why but I will explain later.

    Thanks
    Dave
     
  2. HondaMoCo

    HondaMoCo Senior Member

    Messages:
    322
    Likes Received:
    0
    Joined:
    Jan 8, 2003
    Location:
    lancaster/palmdale So Cal
    it will bolt right in, use the harness that is in your car, it will bolt right up to your tranny (you should get an ex/si tranny though for performance reasons) then you need to either run it off the CX ecu and dont have to do anything, which would be pointless and slow, or you need to get a P28 ecu and run the vtec and oil pressure switch wires
     
  3. 96civic4door

    96civic4door Junior Member

    Messages:
    19
    Likes Received:
    0
    Joined:
    Aug 13, 2003
    You must have you reasons for doing the D16Z6. I dont know what they would be but thats your deal. I just wanted to let you know i have a D16Y8 sitting that im trying to part out if you would like anything just put up a post or email me at WolfPackWalker15@yahoo.com.
     
Verification:
Draft saved Draft deleted

Share This Page