what parts will transfer

[gonzo_gsr]

I wrecked my 92 vx w/b18c1 swap. I plan on using the hasport mount kit to get the b18 and its hydro tranny to fit in my winter car (90 dx hatch.) My question is:
What aftermarket parts that I have on the eg, if any, can I fit on to the ef.
(tanabe racing medallion full exhaust)
(ground control coilovers, kyb shocks, camber kit)
-
Also, with this mount kit, will it be the same as installing the b18 into the eg (wiring, ecu). I did that swap easily, I want this to be the same. Thanks
-Gonzo-

 

[hammerdgolfer]

it should be pretty simple..if you get the rigth stuff,
besides a hydro tranny motor mount kit, you need to get shift linkage, you also need a jdm obd0 vtec engine harness with si resistor box or convert a obd0 ls/gs/rs/si wire harness to vtec,

the springs and struts will fit but on the front of your eg, where the little fork piece holds the strut you need to keep that with the strut becaus they have a littlw wider opening on then then the 88-91's

your going to have to find some kind of ecu to run, youll probably ened a special programed one if you cant find a obd1 to obd0 adapter harness

im not sure about the exhaust but it might