Y7 to replace Z6 how to?

We may earn a small commission from affiliate links and paid advertisements. Terms

joshisakson_

New Member
Hey guys,

I am going to be putting the engine from a 97 Civic DX into a 95 Del Sol Si. How do I do this swap? I am concerned about the OBD 1 and 2. What needs to be done?

Thanks

Going from D16Z6 to D16Y7... what do I need to do?

Thanks
 
yeah pretty much just buy a jumper harness, if there are any other things youll run into them while doing the swap, but i doubt that itll be anything serious, prolly just some wiring and soldering that needs to be done ;)
 
if u do the z6 head on the y7 then u probably still need to buy the jumper harness and then u will have to cut the distibutor connectors out and put the obd1 back on cause they dont match up and u just cut and solder where the wire goes and it works fine
 
Back
Top