1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

zc swap problem

Discussion in 'Civic and CRX - EF' started by 89 hatch, Nov 22, 2006.

  1. 89 hatch

    89 hatch New Member

    Messages:
    40
    Likes Received:
    1
    Joined:
    Nov 22, 2006
    Location:
    fl
    I just did a zc swap on my 89 hatch and now i have a rev limiter a 3000 rpm im using a usdm pg7 89 teg computer with a home made dx to si wiring conversion when i had a sohc in with same ecu and wiring i could rev to 7600 with no problem. it also jerks when im trying to stay at a givin speed say like 45mph i replaced the tps but it did change anything. any suggestions
     
  2. jlicrx

    jlicrx Senior Member

    Messages:
    1,891
    Likes Received:
    65
    Joined:
    Jun 5, 2003
    Location:
    Colorado Springs
    are you showing any codes at the ECU? like 4 or 9?
     
  3. 89 hatch

    89 hatch New Member

    Messages:
    40
    Likes Received:
    1
    Joined:
    Nov 22, 2006
    Location:
    fl
    hey i had code 14 and 10 but i redid my wiring and found that i had the map sensor plugged into the iac motor so it runs great now that i switched the pluggs but does any one know how to ajdust the idle? thank alot for your help though
     
Verification:
Draft saved Draft deleted

Share This Page