1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

zc trans parts into si trans ?...

Discussion in 'HYBRID -> ED-EF / DA' started by 4Door89, Feb 1, 2010.

  1. 4Door89

    4Door89 New Member

    Likes Received:
    Aug 30, 2009
    so i came across a good deal for zc trans parts, gears,FD and LSD, but no case, can and if so how do i get this to fit into a big bearing si trans case...? (no intermediate shaft)

    -what axles to use?
    -does it swap over?
    -is my only option to get the cases/shaft too?

    any help is much needed, thanks
  2. jlicrx

    jlicrx Senior Member

    Likes Received:
    Jun 5, 2003
    Colorado Springs
    the 88-91 ZC transmission uses the same case as the large bearing 88-91 Si transmission - all of the internal parts will swap right in - the ZC differential (including the factory LSD) requires the use of the intermediate shaft and the larger 90-93 Integra type axles - regular axles for the 88-91 L3 Si/DX/LX/EX/HF/STD will not fit into the ZC differential - the inner CV joint splined end that goes into the transmission is too small in diameter - it is 26mm diameter with 25 splines - the ZC uses 28mm diameter with 27 splines
Draft saved Draft deleted

Share This Page