Got a new engine and it ran fine but a week later is tryed it agian. The head had a little more noize than usual. and a few minutes later also my check oil indicator lights up. This engine has an new oil filter and new oil. I suspect that the head isnt getting enough oil or something. What to do...
Her are the vacuum line pics of my old engine and the new one. You can see that the d16a6 has an canister that the d16a9 doesnt have. After cheking everything mij ecu gives the faulty codes 11 and 17. Also my cooling fan doesnt work anymore. I used my new dohc ecu.
These pictures are from this...
The d16a9 dint had a cat. converters i am certain of that. Its an european car. And yes the d16a9 has a sensor less on the pgmfi. After reseting the ecu the rpm is not good. Before resetting the ecu it ran fine but now...
I have a `89 civic 1.6 16v D16A6. This engine is replaced wiht a d16a9 from a ´89 crx. I used my own SI wiring on the d16a9. There are some difrences. The d16a9 has a sensor less on the pgmfi intake. The crx engine doesnt have a catalatic conferter and therefor also no sensor on the outtake...
After putting some new dash lights in my civic i had a short circuit. Now my dash ligts are gone also one of the rear light and my city lights are no more. I have checked all the lights and all the fuses are ok. What to check next?
oh its just the electronics??so if i swap the km/h plates+console off the crx into my civic the speed is accurate. The redline of the crx console is a litle bit higher
I wanted to know if my km/h meter is giving the good speed. I replaced my ED7 for an ED9 engine whit the ED9 gearbox. The crx ED9 has on the meter an topspeed off 220 and my ED7 has an topspeed of 200 on the meter. So what is true? Must i Replace the hole meter concole, just the meter pleats or...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.