Recent content by 8ballsin

  1. 8ballsin

    idle problem

    when you start the car leave it running and unhook the plug on the iacv if it fix the idel problem replace it
  2. 8ballsin

    check cell wiring

    so i finally got an ecu from a untouched 95 civic p28 manual trans and now all my error codes went away except the a/t lock up solinoid so now any ideas
  3. 8ballsin

    D16z6 compression

    its from our local craft shop on post here in german so thanks
  4. 8ballsin

    D16z6 compression

    any ideas why it would be like that
  5. 8ballsin

    D16z6 compression

    i checked my compression on my stock z6 and the normal bolt on mods but my compression was 12, 12, 12, and 13 through each cylinder
  6. 8ballsin

    engine mount question

    to make it bolt right in you have to take the complete driver side mount off your old motor and put it on the new one
  7. 8ballsin

    Z6 w/ Y8 intake mani

    yes you can use his harness plus go on ebay and get a complete OBD to OBD1 conversion kit i paid 120 for mine on ebay
  8. 8ballsin

    1990 CRX SI D16z6 error code problems

    im assuming not i bought it on ebay but since it is flashing a a/t code i guess its not from a manual and thats probaly why i have so many codes flashing
  9. 8ballsin

    1990 CRX SI D16z6 error code problems

    ok so i did the jumper and got 8 codes i have a m/t and i got code (5,6,9,14,19,21,22,and 41) any suggestions my set up is D16z6 block, D15b2 tranny, D16a6 intake mani with OBD0 harness with ebay OBD1 conversion harness witch comes with dizzy adaptor, vtec wiring, 02 sensor, and ecu conversion...
  10. 8ballsin

    check cell wiring

    ok so i did the jumper and got 8 codes i have a m/t and i got code (5,6,9,14,19,21,22,and 41) any suggestions my set up is D16z6 block, D15b2 tranny, D16a6 intake mani with OBD0 harness with ebay OBD1 conversion harness witch comes with dizzy adaptor, vtec wiring, 02 sensor, and ecu conversion...
  11. 8ballsin

    coolant temp sensor

    well i replaced the iacv and the idel still jumps so heres the question im using a d16a6 mani does the z6 have a iac valve and if so where is it located is it on the z6 mani as well because when i drive without it hooked up it drives fine just jerks alot in look rpms like it has alot of power
  12. 8ballsin

    D16z6 TB on D16a6 Mani

    b series anything is very hard to come by here in germany but thanks for the tip
  13. 8ballsin

    check cell wiring

    can u show me a picture with instructions
  14. 8ballsin

    check cell wiring

    no it just had the names of every connections
  15. 8ballsin

    check cell wiring

    its is part the conversion harness from ebay
Back
Top