Calesta, I am in Del Rio, Texas and get all my paint work done in Mexico, I had my Cobra painted there and am getting ready to take my hatch over for paint. They are slow but do excellent work...cheap. Less than a grand. My friend just took his explorer there (he roled it being stupid) they are...
I have an LSD cable in my car and it is a Y1, also it has a stamp on the top of the bell housing with the letters ( LSD ). The individual was correct with the info looking through the axle holes....bar=non/lsd....no bar=LSD.
Any B-series will fit, I use a Y1 Lsd tranny behind my B20 in a 1990 Civic. www.hmotorsonline.com is where I bought my engine and tranny. Axles I use are 91 integra, the prefered axles are the 88-89 integra pieces.
good luck
The big question is what is your budget and skill level in honda swaps....is your hatch an Si or DX? This will set the process back a little if it is a DX like mine (wiring). Get deep in the internet and into the wiring diagrams before you start. There are also a few install tricks myself and...
I don't know why it torque steers so hard...It is a B20 with average mods and an Lsd tranny...axles are 91 integra pieces stuffed though 91 integra front suspension in a 1990 Civic hatch. Third gear is the worst...probably because it is just starting to hook.
Good call, V-8's have used one bolt since the dawn of the gas engine to hold distributors and I have had no problem so far. I would like to see MSD make a distributor for a honda, wishfull thinking I guess.
I have done three so far and they mount up utilizing the upper hole only...it is a low cost alternative to an integra distributor...we all know they want a arm and a leg for them...money always the key to trying something thought not to work and sometimes does. There have been no high arm...
I will have to park mine for a year within the next month and I will miss the power...though I will get to play with some Daihatsu's or Daewooo's ( however it is spelled). Korea calling my name...Japan just a ferry ride away (J-spec part hunting in Japan..can't wait)!
My friend has a B16a crx and broke off the set screw on the ignition rotor and I swapped his distributor with the old one out of his non/vtec sohc 1.6 with his dohc 1.6 vtec with no trouble and no extra wires because the vtec has nothing to do with the distributor. I had to remove the lower...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.