Recent content by BlackDelSol

LMAO

try it one more time

Everyone join and help support the site, post somthin in the Import section to show your support thanks http://www.StreetSMARTSforum.org

Harbor freight tools has 750lb engine stand perfect for honda engines for $40 and $5 shipping, if you order somthin else so your total come out to over $50 then shipping is free on your whole order. http://www.harborfreight.com/ and i also buy from Northern tools, but they dont got alot of...

if you smell gas then you have a fuel leak. if your car was running rich you woulnt smell gas, you would just see a little darker exaust. my car was doing the same thing, when it would stand still or if i had the A/C on it would smell like gas and when i drive it the smell would go away. and i...

ok, well, whats the most hp i can get out of this on a built d16? and if i put a differant wastegate on, what is the max PSI i can run?

I traded a guy on H-T, my nitrous tank for a small turbo. The turbo is an IHI serial# RHB5 12288. what is the max psi for this turbo? (the guy i taded with said that it could handle up to 20PSI) and how would i rais the max psi? bigger compressor housing and wastgate?

How would i hook up an catch can on a turbo d16? it will have a breather filter on it and not go into the intake, so i dont need the pcv valve do i?

Anyone else got some pics?

i want the motor, what engine does it have? the stock d16a6 or a1? (not shure wich one) Oh, and i'm in woodbridge va, so i can pick it up any time, i'll buy the whole car if you give me a realy good price. :D

lol. thanks, i'm not gona fight with you about it, i think i'm right (I'v been talking to him alot for the last 6 months, he made his name on H-T becaus of his engine, not the other way around) , and you think your right, it doesnt realy matter. anyways, yea, you have to notch your block for the...

A "panda" d series is called a panda because it uses toyota pistons and rings from japan. they are pistons and rings from a Jdm twin turbo supra that or forged aluminume from the factory and fit into a d series block prefect. it also uses b16a rods, but i'm going to have my b16 rods shoot piened...

I'm gona build the "panda" D series engine vary soon, but i dont know witch block i should get. I found a post on www.Dsreies.org about a z6 head vs. a y8 head, but nothing on the block. what block is better for boost? whats the diffeance between the two?

i think jb weld should hold it fine, it's just where the coolant goes through, it's not like there is high pressure there. i'm gona try it when i build my d16 next month.

I posted about this on some one else's thread on this board, because i found it and though i'd share. but have any of you done it before? what do you think about it? Here is the link: http://www.muller.net/sonny/crx/engine/posted.html