Recent content by dubster99

  1. D

    I spanked a Kia!!!

    I've said it once, and I'll say it again... The funniest board on the net, www.streetkiaz.com :P
  2. D

    Swapping JDM B16A into a 92 Integra

    You'd be better off sticking with the LS over getting a b16...or you could get a GSR :P
  3. D

    Rice-iest Part Of YOUR Car

    Rice Free is the way to be! :P
  4. D

    Nitrous and tuning it

    The darkside welcomes all :ph34r:
  5. D

    lsvtec pistons

    You can run high compression with nitrous, it's all in the tuning.
  6. D

    Nitrous and tuning it

    The purple box houses the solenoids and electronics, as mentioned before. The electronics of it control fuel pressure based on the pressure of the nitrous in the bottle, to make sure the a/f ratio is good at all times while spraying. As for the FPR its a good idea, but the inline pump is not...
  7. D

    Ricy-est part for your car

    Werd....CF winshield wipers cough*rice*cough :P I don't know, I can't pick one thing out of there that is the most ricey, they are all pretty damn bad.
  8. D

    B16A or B18B?

    www.thepartstrader.com
  9. D

    New toys on the way!

    If I had the money to drop on one, I would. But for now I'll start with the b16 tranny since the gears are the same, and add in an aftermarket LSD down the road, along with a new final drive maybe.
  10. D

    lsvtec pistons

    If you want a 150 shot you'll need direct port. As for your ignition setup, just get an MSD 6a or something similar. Then you'll want to get a Jacobs Nitrous Mastermind, which is a nitrous controller. You can control the rpm nitrous kicks in at, and the rpm that it achieves full flow, and it...
  11. D

    Skunk Cams

    Crower, Skunk2 stage 2 (copy of jun 3's), Toda. I hope you're getting at least springs and retainers as well.
  12. D

    B16A or B18B?

    There is no replacement for displacement. I'll just leave it at that.
  13. D

    New toys on the way!

    I've been thinking about getting a Corbeau as well :P. But that's after the Rotas with Falken Azenis, JDM b20 block, p&p head with crower springs & retainers and crower 404 cams, and a b16 tranny :P Ahh the neverending list.
  14. D

    intercooler clearence

    All you need is to shave the stock bumper a little bit probably. And I'm with Mike about painting the IC black!
  15. D

    Skunk Cams

    If this is a street car, don't get them. They are for race engines only that don't see a lot of mileage. They put extreme stress on the stock rocker assembly, and over mileage will cause them to go bad. Stick with the stage 2's.
Back
Top