Recent content by egb19c

  1. E

    b18b1 swap- OBD1 issue

    Sounds like a bad jumper harness to me
  2. E

    B18 Swap civic

    550cc injectors will be good for around 8-10lbs of boost from a common t3/t4 turbo. I'd recommend going with some precision or I.D. 1000cc so you have room to grow... Don't forget you will need a chipped ECU to run the larger injectors also..
  3. E

    Quick 92 eg question

    Yes, your car has the VTEC wires from the ECU to the shock tower ONLY. You just need to make sure the engine harness you use is the Si, GSR, etc...
  4. E

    ecu for b20/vtec

    My suggestion would be a P28 chipped for your engine. P72 doesn't run enough fuel for the B20 vtec. HA Motorsports has chipped P28's with a free basemap for $159.. Socketed and Chipped OBD1 P28 VTEC ECU | HA Motorsports
  5. E

    PR3 pistons onto LS rods?

    Yes, LS and Pr3 pistons are simple press fit. No machining: Compatible rod/piston combo's without maching.. * LS/B16/B20 * GSR/ITR/CTR
  6. E

    Need ECU advise putting 99 civic ex motor in 96 ex chasis

    Use the 96 ex engine harness in the 96 chassis.
  7. E

    b16 into eg wiring

    obd1 distributor internals do not fit in the obd0 housing.. ;) Use your 94 eg's engine harness and extend vtec wiring and Intake air temp wires to reach on the b16. Then either chip your stock ecu to run the b16, get a chipped p28 from HA Motorsports for the b16, or pick up an obd1 p30 (good...
  8. E

    HELP vtec controller

    Yes, you can wire a VTEC controller, you'll just need to tap into pos battery power to feed the vtec solenoid input on the controller. IMO VTEC controllers are complete garbage. They don't adjust the fuel and timing as needed when vtec engages. Just get a chipped P28 with H22 basemaps and be...
  9. E

    Cr-vtec na

    roflmao... Seriously though, just get a Hondata S300 setup: Hondata S300 System, Hondata S300 USDM Engine Management System
  10. E

    WTB: Hondata s100

    I have the blank SST27sf512 chips, but are you looking for just the chip, or the S100 setup??
  11. E

    i need chip burn for my 0bd0 pr4 ecu

    Then get a life and get off the dope and come back when your sober :mellow:
  12. E

    91 hatch with d16z6 prob

    The spark plug tube seal is leaking ??
  13. E

    b16a3 in eh/eg civic

    Best place I've found for Hasport stuff, had great experiences with them. They have the Hasport axles for your setup if you don't want a cheap set Hasport Axles - B Series 92-00 Civic / 93-97 Del Sol / 94-01 Integra
  14. E

    b16a3 in eh/eg civic

    you can use the 94+ integra axles or del sol VTEC (dohc) axles
  15. E

    Swap B18 into EG

    You will need either a jumper from OBD1 to OBD2, or the better option, install a chipped P28 with an ITR basemap
See more
Back
Top