Recent content by habit

Just go with the best.

Isn't the ITR b-pipe stainless? I think it is. I have to ask my friend again. He has it on his EG Hatch.

A square engine is when the bore = stroke. K20A 86mm x 86mm. Oversquare would be B16A 81mm x 77mm. Undersquare B18C1/5 81mm x 87.2mm. This does not affect your rod stroke ratio at all. B16A has a 1.74 r/s from: 134.37mm divide by 77.4mm= 1.736 I hope that is helpful at all? Just trying...

You should have a dashpot diaphram on the TB if its a Non-obd. And like everyone else said if you have a Map sensor on the TB then you have obd-1.

I like the sound of the Mugen one. That's a nice sounding one. I also like the Spoon N1 as long you have the cat and a resinated b-pipe. I like.

did you email me man...i didn't get a msg. PM me or AOL me. talk to you in a bit.

Never used hondata on a turbo application but, on a NA setup good stuff. I would reconmend.

If you don't want to change the valvetrain. I would say CTR.

Fits right on. Some ppl say you have too balance. But i'm not too sure if that is true.

Yeah there has always been that problem with JDM flywheels getting eaten from starters. I know from the B-series you jsut have to use the B16A starter. And its all good. Can't wait to use my Spoon flywheel. :)

Hey there AP1 Injectors. That's why they fit into your harness.

Would you be interested in CTR ones?

Hey what about Slipstreams?

Man soak it with some WD-40 or something like it. Works.

They look like Jun Flywheels. I wonder if they are the same company. You know Japan likes to rebadge there products.